5 DIY Plastering Tips for Beginners

Plastering is usually deemed difficult job even by professional builders and most of the people prefer to hire a professional plasterer canberra.

It is not an easy-to-do thing for beginners. Many skills needed for the job is not easy to master. The techniques involved in plastering might be difficult to tackle, especially if you are a homeowner and do not know the proper methods.

Plastering might be new for you, but with time, patience and proper knowledge of details your efforts can be rewarding.

You want to give it a try, then read the following points and learn what you need and how you can go about it.

1: Buy tools first


First thing you need to have is tools for plastering. In the complete process you will be needing, sandpaper,plaster, sponge, a stick to mix, a ladder (in case a higher surface needs fixing),  a trowel and hawk for applying and holding plaster, jointing knife, a bucket and clean water.

Do not overburden your forearms. Try to buy plastic hawk (also called hand board) because it is light and easy to hold while you apply plaster. And obviously safety comes first. If you are allergic to the dust, do not forget to add dust mask in your list.

It might cost a lot but the end results will be satisfactory.

2: Prepare the surface first

Plaster does not get along with dusty and already wallpapered surface. Many beginners overlook this important step and end up in getting bumpy and uneven surface. Before beginning the process, make the surface clean and smooth. You need to scrap and brush down all the loose areas of existing plaster.

Plus, it is essential to know the nature of the surface before plastering. You need to determine whether the surface has low or high level suction as it would have an impact on the finish of the work.

3: Prepare a good mixture

Making a good mixture of plaster and water is not a rocket science, but requires you to follow the tricks properly . A good mixture needs clean tap water and plaster in equal proportion. You need to make sure you add equal parts of both in a bucket and mix it well with a clean stick. Ensure your mixture is lumps free and has good consistency. Check it with mixing stick before applying it on the surface.

In case you have mixture more than you needed, keep it in a air tight bucket and it will last for days.

4: How to apply plaster

If you stand far away from the wall and try to cover large areas in one go might turn into a mess. Stand close and go slow. Remember plaster begins to set in 45 minutes or an hour, so don’t rush it.

Plastering is time-consuming process, but it repays.

Leave a Reply

Your email address will not be published. Required fields are marked *